Most products on the market only refill the refrigerant. CarFix is an innovative formula that acts as a full A/C service in 5 stages:

1. 💧 Desiccant: Binds moisture from the system (without creating a vacuum!), preventing corrosion and valve freezing.
2. 🛡️ Sealer: Eliminates micro-leaks in aluminum components.
3. ⭕ Rubber Sealer: Regenerates hardened gaskets and o-rings, restoring airtightness.
4. 🛢️ Oil: Lubricates and quiets the compressor, protecting it from seizing (the most expensive type of failure!).
5. ❄️ Cooling Gas: An ecological, lighter replacement for R134a. It works more efficiently and at lower pressure, reducing the load on the system. 

(Tip: 1 can of CarFix = 453g of R134a refrigerant. Sufficient for most passenger cars).

Clean air conditioning isn't just about low temperatures; it's primarily about healthy air.

• Instant Action: Quickly penetrates vents, upholstery, and carpets.
• Long-lasting Effect: Effectively eliminates unpleasant odors, leaving the interior fresh for a long time.
• Simple Application: Start it, close the car for a few minutes, and you're done. Your lungs will thank you!

This product is suitable for cars from 1994 - 2016 (R134a refrigerant) equipped with a low-pressure LP port (11 mm).

🛑 ATTENTION - EXCEPTIONS:

Before purchasing, check under the hood:

• Do you have a Renault (Laguna II, Megane II/III, Espace IV) or a Nissan (2003-2009)? These cars often do not have an LP port, only a high-pressure (HP) port. If you see only one valve, you need an adapter. 👉 [CLICK TO BUY HP/LP ADAPTER]
• Is your car from 2017 or newer? You likely require R1234yf refrigerant. This kit will NOT fit. 👉 [GO TO R1234yf KIT]

(No tools or mechanical knowledge required)

1. Prepare the hose: Ensure the needle in the valve is retracted (knob fully to the left), then screw the can tightly onto the hose.
2. Connect: Start the engine, set the temperature to the lowest and the A/C fan to "MAX" (internal circulation). Locate the LP port under the hood (thicker aluminum pipe) and plug in the quick-connector (you will hear a "click").
3. Fill: Turn the knob to the right (to puncture the can), turn the can upside down, and unscrew the valve.
4. Observe: Load until the gauge needle stabilizes in the green zone (40-45 PSI).
5. Done: Close the valve, disconnect the hose, and enjoy the cool air!

1. Preparation: Close the windows, start the engine, and set the vents to maximum power and the lowest temperature (internal circulation).
2. Application: Place the can on the floor behind the driver's seat, press the nozzle until it locks, and exit the car, closing the doors tightly.
3. Refreshing and Airing: Wait 10-15 minutes for the product to fill the interior. Then, open the doors and thoroughly air out the car before driving.

1. Is CarFix gas safe for my car and the environment? Yes. The preparation is a mixture of natural hydrocarbons, 100% safe for the environment (does not deplete the ozone layer). For your car, it is actually "healthier" than the original R134a – CarFix operates at lower pressure, which significantly unburdens the compressor and extends its lifespan. Additionally, it does not form acids when in contact with moisture, eliminating the risk of internal corrosion.
2. Can I mix CarFix with the remaining old gas in the system? Yes. The CarFix formula is fully compatible and mixes with R134a refrigerant. You do not need to empty the system completely before using our kit. Just remember to monitor the pressure gauge during the top-up and do not overfill the system (keep the needle in the green zone).
3. How do I know where the LP valve is located? Look for the Low Pressure (LP) port. It is usually located on the thicker aluminum line and is protected by a black or blue cap. The port diameter is approximately 11 mm. Our quick-connector fits ONLY the LP port, so it is physically impossible to connect it to the wrong place (the HP port, which is larger), unless your car requires an adapter (e.g., some Renault models).
4. What if my air conditioning is completely empty? One can of CarFix contains the equivalent of 453g of R134a refrigerant. This amount is sufficient to fill the system in most standard passenger cars (where system capacity is usually 450-600g). However, if you have a large vehicle (SUV, Van, Minivan) or your system is completely empty, we recommend purchasing a kit with two cans to achieve full cooling efficiency.
5. Will this kit fix every leak? CarFix 5-in-1 contains a sealant that effectively eliminates micro-leaks in rubber elements (o-rings, gaskets) and minor leaks in aluminum. However, please note that if there is major mechanical damage (e.g., a hole in the radiator from a stone, a cracked hose), the gas will escape. The product is intended for maintenance regeneration, not for repairing mechanically broken parts.
6. Can I handle this if I don't know anything about mechanics? Definitely yes. The kit was created with individual users in mind. The entire process boils down to connecting the hose (with a "click") and opening the valve. You don't need any additional tools. We include instructions with every kit, and instructional videos are available on our website.

Use CarFix not only in the summer! A working air conditioning system allows you to instantly defrost windows in autumn and winter and prevents the growth of fungi and mold in the car.